HelpOnSlideShows

You can easily create slide shows using the <<Navigation>> macro.

For a new presentation, start on a new page - we use HelpOnSlideShows (this page) as an example.

For your convenience, there is a SlideShowTemplate - use it!

Put <<Navigation(slideshow)>> on top of that page (looks like you see above) - that creates a link to toggle between slide show and wiki mode, and a link to start the slide show.

Refer to your slides with numbered sub-page links putting some code like that on your top page:

 * [[/000 Introduction]]
 * [[/100 Creating the slides]]
 * ...
 * [[/900 Last but not least: Running your presentation.]]
 * ../SlideShowHandOutTemplate

(!) Leave some numbers free in between - just for that case you need to insert additional slides later.

(!) Don't use too long page titles - you will see that they look bad (at least in wiki mode due to wrapping of the wiki page title).

This will look like that:

You may want to put <<Navigation(children)>> at bottom of the page - that lists the pages' child pages and looks like you see below:

This site is hosted by NedCAD.

De inhoud van deze site wordt aangeboden zoals het is, zonder enige vorm van garantie en heeft verschillende licenties. Meer informatie over licenties staat hier.